User's Guide
Table Of Contents
RU224 Initial Startup
1. Connect HDMI cable, Ethernet Cable (if necessary), GPIO Connectors (If Necessary),
keyboard and mouse to the RU224.
2. Power the Reader
2.1. Plug the power cable to the reader, there will be a short beep sound which indicates
that the reader is on.
3. Connect the Antenna(s) to the Reader
3.1. Connect your Antenna to the Antenna Port. Please note that arrangement of the
Antennas start from the leftmost as Antenna 1. *This will direct you on how to control
the Antennas using the Software.
3.2.Connect up to 4 Antennas according to your requirements."
Page ! of !17 39
Pin 1
Pin 8