User's Manual

WatchMan3000NB24
© GIGA-TMS INC.
2 Operation
Patrol recording, transferring records to PC and erasing.
2.1 Record Patrol
Fix the RFID tags supplied with WatchMan3000NB one each at selected locations on the route to be
covered during patrol. Instruct the personnel to scan the tags during patrol as follows:
1. Switch on handset WM3000NB.
2. Press the scan button on the side.
3. Bring it near the tag (6 to 7 cm's) till a beep is heard.
The beep sound indicates successful recording of the location/tag code. The handset display will show
the code of the last tag scanned.
WatchMan3000NB can store about 8192 records after which the old records have to be deleted to
make space for new. Before deletion, all records can be transferred and saved to a PC.
2.2 Transfer Records to PC
Connect base unit BC3000N to PC's USB port using the RS232-USB cable . Plug the jack of 5 V dc
adaptor supplied with the product into pin socket of BC3000N.
Next, insert the handset WM3000NB firmly into the slot on top of base unit BC3000N. The message
'Cradle Detected' will appear on the display.
If the PC is already installed with WatchMan Monitor software, connect handset WM3000NB and base
unit BC3000N to PC as described in Connect Device
(If the PC is not already installed with the WatchMan Monitor software, install it by following procedure
in Chapter 1.3 Install Software
and then connect device.)
Next go to Start menu and click open WatchMan Monitor.