Owner's Manual

English

1-4 Water Block and VGA Card Installation

Apply the grease on the VGA chipset as shown in Fig. c.

Insert the screws on the water block into the mounting holes

as shown in Fig. d.

As shown in Fig. e, determine the position of the base plate

(Component 12) so that its mounting holes line up with the

mounting holes on the VGA radiator. Place the washers

(Component 13) on the lined up mounting holes, as shown in

Fig. e.

Place the base plate (Component 12) in the desired position

as shown in Fig. f.

Fig. f

Bolt the base plate using the supplied spring loaded screws

(Component 10) as shown in Fig. g.

Fig. g

To avoid damage on the chipset, due to over

pressure while securing the spring loaded

screws, please fasten the screws diagonally.

Washer

Fig. e