User's Manual
Table Of Contents
- Safety_Precautions
- _bookmark1
- Introduction
- Unpacking
- _bookmark2
- Product_Overview
- _bookmark4
- Getting_Started
- Installing_the_Monitor_Base
- _bookmark5
- Adjusting_the_Viewing_Angle
- _bookmark6
- Installing_a_Wall-Mount_Bracket_(Optiona
- _bookmark7
- Using_the_Device
- Turning_the_Power_On/Off
- _bookmark9
- Selecting_the_Input_Source
- _bookmark11
- Operations
- Quick_Menu
- _bookmark12
- _bookmark14
- Configure_the_Device_Settings
- _bookmark15
- _bookmark17
- _bookmark19
- _bookmark20
- _bookmark21
- Appendices
- Specifications
- _bookmark23
- Supported_Timing_List
- _bookmark24
- Troubleshooting
- _bookmark25
- Basic_Care
- Notes_on_USB_Charging
- GIGABYTE_Service_Information
- _bookmark26
- SAFETY INFORMATION
- INTRODUCTION
- GETTING STARTED
- USING THE DEVICE
- OPERATIONS
- Quick Menu
- APPENDICES
LCD Monitor User's Manual
-
18
-
2.
Lift the assembled Stand & Base to an upright position and place it on a table.
Then lower the stand plate to allow the safety plate to automatically release
from its slot.
3.
Place the monitor on the package cushion or a at surface, with screen facing
down. Tear apart the EPE bag, install the stand on the rear side of the monitor.
Then you can take the monitor from the lower EPS foam by holding the stand
arm. Carefully lift the monitor. Place it upright on a table.