User`s manual

Hardware Installation - 14 -

1-3-2 Installing the CPU Cooler

Follow the steps below to correctly install the CPU cooler on the motherboard. (The following procedure uses

Intel

boxed cooler as the example cooler.)

Use extreme care when removing the CPU cooler because the thermal grease/tape between the

CPU cooler and CPU may adhere to the CPU. Inadequately removing the CPU cooler may damage

the CPU.

Step 1:

Apply an even and thin layer of thermal paste on

the surface of the installed CPU.

Male Push

Female

Push Pin

The Top

of Female

Push Pin

Direction of the

Arrow Sign on

the Male Push

Step 2:

Before installing the cooler, note the direction of

the arrow sign on the male push pin. (Turning

the push pin along the direction of the arrow is

for removing the cooler, and the opposite

direction is for installing it..)

Step 3:

Place the cooler atop the CPU, aligning the

four push pins through the pin holes on the

motherboard. Push down on the push pins

diagonally.

Step 4:

You should hear a "click" when pushing down

each push pin. Check that the Male and Female

push pins are joined closely. (Refer to your CPU

cooler installation manual for instructions on

installing the cooler.)

Step 5:

After the installation, check the back of the

motherboard. If the push pin is inserted as the

picture above shows, the installation is complete.

Step 6:

Finally, attach the power connector of the CPU

cooler to the CPU fan header (CPU_FAN) on the

motherboard.