Quick Start Manual

- 3 -

English

Remove the original I/O shield from the back of the case and replace it with the

motherboard I/O shield. Place the motherboard within the case by positioning it

into its I/O shield. Align the mounting screw holes on the motherboard with their

corresponding mounting holes on the case. Secure the motherboard in place

with screws.

Locate an expansion slot that supports your card and remove the slot cover from

the case back panel. Then insert the expansion card into the slot. Secure the

expansion card's bracket to the case back panel with a screw.

I/O Shield

• Before purchasing an expansion card, check the length of the card, making

sure it can t into your case.

• Make sure that the expansion card is fully seated in its slot.

Step

Installing the Motherboard

Step

Installing an Expansion Card

PCI Express Graphics Card

6-1 Install your optical drives, such as DVD-ROM and CD-ROM drives.

Remove the 5.25" drive bay cover from the front of the case. Mount the optical drive

in the 5.25" drive bay and secure it with screws.

6-2 Install your IDE and SATA hard drives.

Install the hard drive into a drive bay within the case and secure it with screws.

• One motherboard IDE connector can connect up to two IDE devices. Prior to installation, check the jumper

settings (master and slave) on your IDE devices.

• If more than one hard drive is installed, enter system BIOS Setup to set the hard drive boot sequence.

Installing an Optical Drive

Installing a Hard Drive

Step

Installing IDE and SATA Devices