User`s manual

- 87 - Appendix
5-1-2 Conguring GIGABYTE SATA2/JMicron JMB362 SATA Controller
A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available
SATA port on the motherboard. See the table below for the SATA controllers and their corresponding SATA
ports. Then connect the power connector from your power supply to the hard drive.
B. Conguring SATA controller mode in BIOS Setup
Make sure to congure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). Go
to the Onboard PCIE Devices sub-menu under the Integrated Peripherals menu. See the table below for
conguring different SATA controllers for RAID (Figure 1).
Controller Connectors BIOS Settings
GIGABYTE GSATA2_6/7 Set Onboard GSATA controller
to
Enabled
SATA2 Set Onboard GSATA Mode
to
RAID/IDE
JMicron eSATA ports Set Onboard ESATA controller to Enabled
JMB362 Set Onboard ESATA Mode
to
RAID
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Onboard PCIE Devices
 PrimaryDualSlotCong  [Auto]
 SecondaryDualSlotCong  [Auto]
 PCIEX4_2SlotCong   [AsX1Link]
Onboard GSATA controller [Enabled]
Onboard GSATA Mode [RAID/IDE]
Onboard ESATA controller [Enabled]
Onboard ESATA Mode [RAID]
Onboard LAN1 Function [Enabled]
Onboard LAN1 Boot ROM [Disabled]

SMART LAN1 [Press Enter]
Onboard LAN2 Function [Enabled]
Onboard LAN2 Boot ROM [Disabled]

SMART LAN2 [Press Enter]
higf
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

Figure 1
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Step 2:
Save changes and exit BIOS Setup.