Owner's Manual

GA-EP35-DS3L/S3L Motherboard - 24 -

8) IDE1 (IDE Connector)

The IDE connector supports up to two IDE devices such as hard drives and optical drives. Before

attaching the IDE cable, locate the foolproof groove on the connector. If you wish to connect two IDE

devices, remember to set the jumpers and the cabling according to the role of the IDE devices (for

example, master or slave). (For information about configuring master/slave settings for the IDE

devices, read the instructions from the device manufacturers.)

240

139

9) SATAII0/1/4/5 (SATA 3Gb/s Connectors, Controlled by ICH9)

The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s

standard. Each SATA connector supports a single SATA device.

Pin No. Definition

1 GND

2 TXP

3 TXN

4 GND

5 RXN

6 RXP

7 GND

SATAII0

SATAII1

SATAII4

SATAII5

Please connect the L-shaped end

of the SATA 3Gb/s cable to your

SATA hard drive.