Owner's Manual

GA-EP35-DS3L/S3L Motherboard - 40 -

SMART LAN (LAN Cable Diagnostic Function)

This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN

cable. This feature will detect cabling issue and report the approximate distance to the fault or short.

Refer to the following information for diagnosing your LAN cable:

When No LAN Cable Is Attached...

If no LAN cable is attached to the motherboard, the Status fields of all four pairs of wires will show

Open and the Length fields show 0m, as shown in the figure above.

When LAN Cable Is Functioning Normally...

If no cable problem is detected on the LAN cable connected to a Gigabit hub or a 10/100 Mbps hub,

the following message will appear:

Link Detected Displays transmission speed

Cable Length Displays the approximate length of the attached LAN cable.

Start detecting at Port.....

Link Detected --> 100Mbps

Cable Length= 30m

SMART LAN

Item Help

Menu Level`

Start detecting at Port.....

Part1-2 Status = Open / Length = 0m

Part3-6 Status = Open / Length = 0m

Part4-5 Status = Open / Length = 0m

Part7-8 Status = Open / Length = 0m

KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help

F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults

USB Mouse Support

Allows USB mouse to be used in MS-DOS. (Default: Disabled)

Legacy USB storage detect

Determines whether to detect USB storage devices, including USB flash drives and USB hard

drives during the POST. (Default: Enabled)

Azalia Codec

Enables or disables the onboard audio function. (Default: Auto)

If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item

to Disabled.

Onboard H/W LAN

Enables or disables the onboard LAN function. (Default: Enabled)

If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item

to Disabled.