Owner's Manual

- 26 -
********
Mother Board Voltage Control
********
>>> CPU
CPU Vcore
The default is Auto.
CPU Termination
The default is Auto.
>>> DRAM
DRAM Voltage
The default is Auto.
2-4 Standard CMOS Features
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
Standard CMOS Features
Date (mm:dd:yy) Thu, Jul 5 2011
Time (hh:mm:ss) 22:31:24

IDE Channel 0 Master [None]

IDE Channel 0 Slave [None]

IDE Channel 2 Master [None]

IDE Channel 2 Slave [None]

IDE Channel 3 Master [None]

IDE Channel 3 Slave [None]
Halt On [All, But Keyboard]
Base Memory 640K
Extended Memory 988M
Total Memory 990M

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

Date (mm:dd:yy)
Sets the system date.
Time (hh:mm:ss)
Sets the system time.
IDE Channel 0, 2, 3 Master/Slave
IDE Channel 0 Master/Slave, Extended IDE Drive
Congure your IDE/SATA devices by using one of the three methods below:
None If no IDE/SATA devices are used, set this item to • None so the system will skip
the detection of the device during the POST for faster system startup.
Auto Lets the BIOS automatically detect IDE/SATA devices during the POST. (Default) •
Manual Allows you to manually enter the specications of the hard drive when the hard •
drive access mode is set to CHS. (For IDE Channel 0 Master/Slave only.)
Access Mode Sets the hard drive access mode. (Default: Auto)
The following elds display your hard drive specications. If you wish to enter the parameters manually,
refer to the information on the hard drive.
Capacity Approximate capacity of the currently installed hard drive.
Cylinder Number of cylinders.
Head Number of heads.
Precomp Write precompensation cylinder.
Landing Zone Landing zone.
Sector Number of sectors.