Quick Start Manual

SATA Configurations (Nvidia nForce430)- 13 -
Figure 20
Step 4:
When the next screen (Figure 19) appears, press ENTER to continue the SATA driver installation from
the floppy disk.
Figure 19
Windows Setup
S=Specify Additional Device Enter=Continue F3=Exit
Setup will load support for the following mass storage device(s):
NVIDIA RAID CLASS DRIVER (required)
NVIDIA nForce Storage Controller (required)
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
After the SATA controller driver installation is completed, you should see a screen similar to that below.
You can proceed with the Windows 2000/XP installation now.
WindowsXP Professional Setup
The following list shows the existing partitions and
unpartitioned space on this computer.
Use the UP and DOWN ARROW keys to select an item in the list.
l To set up Windows XP on the seleted item, press ENTER.
l To create a partition in the unpartitioned space, press C.
l To delete the selected partition, press D.
ENTER= Install C=Create Partition F3=Quit
114471 MB Disk 0 at Id 0 on bus 0 on nvraid (MBR)
Unpartitioned space 114471MB