Quick Start Manual

SATA Hard Drive Configurations (Sil3114) - 12 -
Ác
Åé
¤¤
¤å
Figure 19
Figure 17
Step 5:
Insert an empty floppy disk. Select the Sil3114 Raid5 item by pressing the corresponding letter (Figure
18).
Important You MUST select the Sil3114 Raid5 item no matter which RAID mode you created. If you
wish to set up a non-RAID configuration (or single hard drive), you must select Sil3114 Raid5, too. After
selecting Sil3114 Raid5, your system will then automatically zip and transfer this driver file to the floppy
disk.
Step 4:
Double-click MENU.exe. An MS-DOS prompt screen similar to Figure 17 below will appear.
Step 6:
Press 0 to exit when the procedure is complete (Figure 19). You have copied the SATA driver
successfully.
Figure 18
Selecting Sil3114 or Sil3114 Raid from the menu will result in the failure to install operating
system during OS installation.