Quick Start Manual

SATA Hard Drive Configurations (Sil3114)- 3 -

(2) Enabling SATA controller in BIOS Setup

Assure that the SATA controller is enabled in system BIOS Setup.

Step 1:

Turn on your computer and press Del to enter BIOS Setup during POST (Power-On Self Test). In BIOS

Setup menu, go to Integrated Peripherals and assure that SATA RAID-5 Function (Figure 1) is

enabled. Please note that SATA RAID-5 Function is to enable or disable the Sil3114 controller. To set

either RAID or non-RAID mode (or single hard drive), you MUST enter the Sil3114 RAID BIOS utility.

The BIOS Setup menus described in this section may not show the exact settings for your

motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard

you have and the BIOS version .

Integrated Peripherals

KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help

F5: Previous Values F7: Optimized Defaults

Figure 1