Quick Start Manual

SATA Hard Drive Configurations (Sil3114) - 4 -

Ác

Åé

¤¤

¤å

Figure 2

While you are in the RAID BIOS, you should see a screen similar to that below (Figure 3). Use the UP

or DOWN ARROW key to highlight through choices. Highlight the item that you want to execute and

press ENTER.

Figure 3

(3) Configuring SATA hard drives in RAID BIOS

To configure either RAID or non-RAID boot drive/data drive or single hard drive, you MUST enter the

the Sil3114 SATA RAID BIOS setup utility.

After the POST memory test begins and before the operating system boot begins, look for a message

which says "Press <Ctrl+S> or <F4> to enter RAID utility"(Figure 2). Hit the CTRL+ S or F4 key to enter

the RAID BIOS setup utility. If you cannot enter the RAID BIOS , assure that your SATA drives are properly

installed.

Create RAID set

Delete RAID set

Rubuild Raid1 set

Resolve Conflicts

Low Level Format

Logical Drive Info

MAIN MENU

HELP