Quick Start Manual

SATA Hard Drive Configurations (Sil3114)- 5 -

3-1 Configuring single hard drive or non-RAID boot drive/data drive

Since the RAID BIOS no longer reports non-RAID drives to the system BIOS, if you wish to install a single

hard drive or configure non-RAID boot drive or data drive, you MUST set the hard drive(s) to JBOD

mode in RAID BIOS so the RAID BIOS will report it to the system BIOS.

Step 1:

Select Create RAID set and press ENTER, and the RAID type selection menu will appear. Use the UP

or DOWN ARROW key to select JBOD (Single) (Figure 4) and press ENTER.

Step 2:

Select the JBOD hard drive from the physical drive list and press ENTER.

Step 3:

Select the JBOD hard drive size (Figure 5). You should see the default size set by the RAID BIOS. To

change the default size, use the UP or DOWN ARROW key. Press ENTER after setting the JBOD size.

Figure 4

Figure 5