Owner's Manual

GA-M61PME-S2P Motherboard - 72 -
Rebuilding an Array:
Rebuilding is the process of restoring data to a hard drive from other drives in the array. Rebuilding
applies only to fault-tolerant arrays such as RAID 1 array. The procedures below assume a new drive
is added to replace a failed drive to rebuild a RAID 1 array. (Note: The new drive must have equal or
greater capacity than the old one.)
Turn off your computer and replace the failed hard drive with a new one. Restart your computer. While
in the operating system, launch the NVIDIA Control Panel from All Programs in the Start Menu.
The rebuild is automatically performed after en-
tering the operating system. You can see the
rebuild progress on the View Storage Con-
figuration sub-menu. When the rebuild is
completed, the array status will display as
Healthy.
Step 2:
When the NVIDIA Rebuild Array Wizard appears,
follow the on-screen instructions to complete
the rebuilding.
Manually rebuilding a hard drive:
Refer to the following instructions if you want to manually rebuild a hard drive in the array.
Step 1:
In NVIDIA Control Panel, click Rebuild array
under Storage in the Select a Task pane.
The notification area will also display a
message, indicating the rebuild progress.