Owner's Manual

Hardware Installation- 13 -
Internal Connectors  1 x 24-pin ATX main power connector
 1 x 4-pin ATX 12V power connector
 1 x floppy disk drive connector
 1 x IDE connector
 6 x SATA 3Gb/s connectors
 1 x CPU fan header
 2 x system fan headers
 1 x power fan header
 1 x front panel header
 1 x front panel audio header
 1 x CD In connector
 1 x S/PDIF In/Out header
 2 x IEEE 1394a headers
 4 x USB 2.0/1.1 headers
 1 x parallel port header
 1 x serial port header
 1 x chassis intrusion header
 1 x power LED header
Back Panel  1 x PS/2 keyboard port
Connectors  1 x PS/2 mouse port
 1 x D-Sub port
 1 x DVI-D port
(Note 6)
 1 x HDMI port
 1 x optical S/PDIF Out connector
 1 x IEEE 1394a port
 4 x USB 2.0/1.1 ports
 1 x RJ-45 port
 6 x audio jacks (Center/Subwoofer Speaker Out/Rear Speaker Out/Side
Speaker Out/Line In/Line Out/Microphone)
I/O Controller  iTE IT8718 chip
Hardware Monitor  System voltage detection
 CPU/System temperature detection
 CPU/System/Power fan speed detection
 CPU overheating warning
 CPU/System fan fail warning
 CPU/System fan speed control
(Note 7)
BIOS  2 x 8 Mbit flash
 Use of licensed AWARD BIOS
 Support for DualBIOS
TM
 PnP 1.0a, DMI 2.0, SM BIOS 2.4, ACPI 1.0b