Owner's Manual

- 45 - BIOS Setup

2-5 Advanced BIOS Features

Internal Graphics Mode

Allows you to determine whether to allocate the system memory for the onboard graphics controller.

UMA Allocates memory for the onboard graphics controller from the system memory.

(Default)

Disabled Disables the onboard graphics controller.

UMA Frame Buffer Size

Frame buffer size is the total amount of system memory allocated solely for the onboard graphics

controller. MS-DOS, for example, will use only this memory for display. Options are: Auto

(default), 128MB, 256MB, 512MB.

Surround View

This option is configurable only when Init Display First is set to PEG. Enables or disables the

Surround View function. This option is configurable only if an ATI graphics card is installed.

(Default: Disabled)

Onboard VGA output connect

Specifies the graphics display of the onboard VGA output from the D-SUB/DVI-D or D-SUB/HDMI.

Auto BIOS automatically determines the primary display port for output,

depending on to which port the display device is connected, D-SUB/DVI-D

or D-SUB/HDMI. (Default)

D-SUB/DVI Sets the D-SUB/DVI-D as the graphics display.

D-SUB/HDMI Sets the D-SUB/HDMI as the graphics display.

Advanced BIOS Features

Internal Graphics Mode [UMA]

UMA Frame Buffer Size [Auto]

x Surround View Disabled

Onboard VGA output connect [Auto]

Init Display First [PCI Slot]

Virtualization [Disabled]

Patch AMD TLB Erratum

(Note)

[Enabled]

AMD K8 Cool&Quiet control [Auto]

` Hard Disk Boot Priority [Press Enter]

First Boot Device [Floppy]

Second Boot Device [Hard Disk]

Third Boot Device [CDROM]

Password Check [Setup]

HDD S.M.A.R.T. Capability [Disabled]

Away Mode [Disabled]

Full Screen LOGO Show [Enabled]

Dual BIOS Recovery Source [HPA]

KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help

F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults

Item Help

Menu Level`

(Note) This item is present only if you install a CPU that supports this feature.