Datasheet

GA-X48T-DQ6 Motherboard - 54 -
2-9 MB Intelligent Tweaker(M.I.T.)
(Note) This item appears only if you install a CPU that supports this feature.
• Incorrectly doing overclock/overvoltage may result in damage to CPU, chipset, or memory
and reduce the useful life of these components. This page is for advanced users only and
we recommend you not to alter the default settings to prevent system instability or other
unexpected results. (Inadequately altering the settings may result in system's failure to
boot. If this occurs, clear the CMOS values and reset the board to default values.)
• When the System Voltage Optimized item blinks in red, it is recommended that you set
the System Voltage Control item to Auto to optimize the system voltage settings.
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
MB Intelligent Tweaker(M.I.T.)
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level`
x Write To Precharge Delay 6 Auto
x Refresh to ACT Delay 36 Auto
x Read to Precharge Delay 4 Auto
x Static tRead Value 3 Auto
x Static tRead Phase Adjust 0 Auto
x Command Rate (CMD) 1 Auto
********
Clock Driving & Skew Control
********
CPU/PCIEX Clock Driving Control [800mV]
CPU Clock Skew Control [Normal]
(G)MCH Clock Skew Control [Normal]
********
System Voltage Optimized
********
System Voltage Control [Manual]
DDR3 OverVoltage Control [Normal]
PCI-E OverVoltage Control [Normal]
FSB OverVoltage Control [Normal]
(G)MCH OverVoltage Control [Normal]
Loadline Calibration [Enabled]
CPU Voltage Control [Normal]
Normal CPU Vcore 1.37500V
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
MB Intelligent Tweaker(M.I.T.)
Robust Graphics Booster [Auto]
CPU Clock Ratio
(Note)
[25X]
CPU Frequency 3.60GHz(200x18)
CPU Host Clock Control [Disabled]
x CPU Host Frequency (Mhz) 200
PCI Express Frequency (Mhz) [Auto]
C.I.A. 2 [Disabled]
Performance Enhance [Turbo]
System Memory Multiplier (SPD) [Auto]
Memory Frequency (Mhz) 800 800
DRAM Timing Selectable (SPD) [Auto]
********
Standard Timing Control
********
x CAS Latency Time 6 Auto
x DRAM RAS# to CAS# Delay 6 Auto
x DRAM RAS# Precharge 6 Auto
x Precharge delay(tRAS) 15 Auto
********
Advanced Timing Control
********
x ACT to ACT Delay(tRRD) 4 Auto
x Rank Write to READ Delay 4 Auto
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level`