Datasheet

GA-X48T-DQ6 Motherboard - 86 -

C. Configuring a RAID array in RAID BIOS

Enter the RAID BIOS setup utility to configure a RAID array. Skip this step and proceed to the installation

of Windows operating system for a non-RAID configuration.

After the POST memory test begins and before the operating system boot begins, look for a message

which says "Press <Ctrl-G> to enter RAID Setup Utility" (Figure 2). Press <Ctrl> + <G> to enter the

GIGABYTE SATA2 RAID BIOS utility.

Figure 2

Figure 3

GIGABYTE Technology Corp. PCIE-to-SATAII/IDE RAID Controller BIOSv1.06.59

HDD0 : ST3120026AS 120 GB Non-RAID

HDD1 : ST3120026AS 120 GB Non-RAID

ODD0 : DVDROM GO-D1600B

Press <Ctrl-G> to enter RAID Setup Utility ...

In the main screen of the GIGABYTE SATA2 RAID BIOS utility (Figure 3), use the up or down arrow key

to highlight through choices in the Main Menu block. Highlight the item that you wish to execute and

press <Enter>.

GIGABYTE Technology Corp. PCIE-to-SATAII/IDE RAID Controller BIOSv1.06.59

[ Main Menu ]

Create RAID Disk Drive

Delete RAID Disk Drive

Revert HDD to Non-RAID

Solve Mirror Conflict

Rebuild Mirror Drive

Save And Exit Setup

Exit Without Saving

[ RAID Disk Drive List ]

[IJTAB]-Switch Window [KL]-Select ITEM [ENTER]-Action [ESC]-Exit

[ Hard Disk Drive List ]

Model Name Capacity Type/Status

HDD0: ST3120026AS 120 GB Non-RAID

HDD1: ST3120026AS 120 GB Non-RAID

(Note) In the main screen, you can select a hard drive in the Hard Disk Drive List block and press

<Enter> to see detailed information about the selected hard drive.