User's Manual

AS18X/AS28X / en master / A31008-M2001-B101-1-19 / starting.fm / 19.01.2011
5
Registering the handset to the base station
Before you can use the phone, you must first register the handset to the base station.
The actual registration procedure will depend on the type of base station.
Automatically register the Mitel 5505H handset to the base station
Manually register the Mitel 5505H handset
You must activate manual registration of the handset on both the handset and the
base station.
1. On the handset: MENU ¢ Settings ¢ OK ¢ Handset ¢ OK ¢ Register HS
¢ Enter the base station system PIN (default setting: 0000) ¢ OK.
2. On the base station: Within 60 seconds of entering the system PIN, press and hold the reg-
istration/paging key (min. 3 seconds). See also the user guide for the base station.
After successful automatic or manual registration, the idle screen is displayed:
The handset is assigned the lowest unassigned internal number (1–4). If more than one hand-
set is registered to the base station, the internal handset number appears in the top left of the
display, e.g. 2. If the internal numbers 1–4 are already assigned to other devices, number 4 will
be overwritten.
Please note
Only place the handset in the base station or charging cradle that is intended for it.
V
Registering
The handset registers automatically. Reg-
istration can take up to 5 minutes.
Do not remove the handset from
the base station during this time.
V
Put into base
MENU
¤ Place the handset with
the display facing up
in the base station.
V
Registering
The registration screen is displayed.
V
INT MENU
Charge status of the batteries:
– = e V U (flat to full)
– = flashes: batteries almost flat
– e V U flashes: charging