User's Manual

AS18X/AS28X / en master / A31008-M2001-B101-1-19 / starting.fm / 19.01.2011
6
Initial charging and discharging of the batteries
The correct charge level can only be displayed if the batteries are first fully charged and dis-
charged.
Setting the date and time
Set the date and time so that the correct date and time can be assigned to incoming calls, and
so that the alarm can be used.
MENU ¢ Settings ¢ OK ¢ Date/Time ¢ OK
¢ Date: ¢ ~ (enter the day, month and year in 6-digit format) ¢ OK
¢ Time: ¢ ~ (enter hours and minutes in 4-digit format) ¢ OK (display message: Saved)
¢ a (press and hold to return to idle status)
Display in idle status
Once the phone is registered and the time set, the idle display
is shown as in this example.
Activating/deactivating the handset
Press and hold the end call key a to activate or deactivate the handset.
If you place a deactivated handset in the base station or charging cradle, it will automatically
activate.
Your phone is now ready for use!
If you have any questions about using your phone, please read the tips on troubleshooting
("Questions and answers" ¢ page 9) or contact our Customer Care team ¢ page 10.
Please note
◆ After the first battery charge and discharge you may replace your handset in the base
station or charging cradle after every call.
◆ Always repeat the charging and discharging procedure if you remove the batteries
from the handset and reinsert them.
◆ The batteries may warm up during charging. This is not dangerous.
◆ After a while, the charge capacity of the batteries will decrease for technical reasons.
Please note
When entering the time and date, you can move the position of an entry to the left or right
by pressing the control button up or down.
¤ Place the handset in the base station or charging cradle for eight hours.
¤ Then remove the handset from the base station or charging cradle and do
not replace it until the batteries are fully discharged.
8 h
V
11.12. 11:56
INT MENU