User's Manual

48
Using the handset as an alarm clock
Gigaset C300-C300A / Master EN / A31008-xxxx-xxxx-x-xxxx / registr_sett.fm / 16.04.2010
Version 4, 16.09.2005
Using the handset as an
alarm clock
Prerequisite: The date and time have
already been set (¢ page 16).
Activating/deactivating the alarm
clock
§Menu§ ¤ Alarm Clock ¤ Activation (³ =on)
After you activate the alarm clock, the menu
for setting the wake up time opens automat-
ically.
The ¼ icon and wake up time are shown on
the display.
A wake-up call is signalled on the display
(¢ page 3) and with the selected ringer vol-
ume and melody (¢ page 52). The wake-up
call sounds for 60 seconds. If no key is
pressed, the wake-up call is repeated twice
at five-minute intervals and then switched
off.
During a call, the wake-up call is only sig-
nalled by a short tone.
Setting the wake up time
§Menu§ ¤ Alarm Clock ¤ Wake up time
~ Enter the wake up time in hours
and minutes, then press
§OK§.
Deactivating the wake-up call/
repeating after a pause
(snooze mode)
Prerequisite: A wake-up call is sounding.
§Off§ Press the display key. The wake-
up call is deactivated.
Or
§Snooze§ Press the display key or any key.
The wake-up call is deactivated
and then repeated after 5 min-
utes. After the second repeti-
tion, the wake-up call is deacti-
vated completely.
Using multiple handsets
Registering handsets
You can register up to four handsets on your
base station. Each additional handset must
be registered with the base in order for it to
work properly!
Registering the Gigaset handset
with the Gigaset C300/C300A
You must manually register the handset on
both the handset (1) and the base (2).
Once the registration process has been com-
pleted successfully, the handset returns to
idle status. The handset's internal number is
shown in the display, e.g., INT 1. If not, repeat
the procedure.
Registering other handsets
You can manually register other Gigaset
handsets and handsets for other devices
with GAP functionality as follows.
1) On the handset
§Menu§ ¤ Settings ¤ Registration
¤ Register Handset
If the handset is already registered to four
bases:
s Select base, e.g., Base 3 and
press
§OK§.
~ If required, enter the system
PIN for the base and press
§OK§.
The display shows Handset is registering.
2) On the base
¤ Within 60 seconds, press and hold the
registration/paging key on the base
(¢ page 5) (approx. 3 seconds).
1) On the handset
¤ Start to register the handset as
described in its user guide.