User's Manual

52
Connecting the base to the PABX
Gigaset C590/C595 / USA-CAN engl / A31008-M2101-R301-1-3S19 / pabx.fm / 28.07.2009
Version 4, 16.09.2005
Connecting the base to
the PABX
The following settings are only necessary
if your PABX requires them; see the PABX
user guide.
Dialing modes and recall
The current setting is indicated by Ø.
Changing the dialing mode
The following dialing modes can be
selected:
u Tone dialing (DTMF)
u Dial pulsing (DP)
v
¢
Ï
¢ Telephony ¢ Dialing Mode
s Select dialing mode and press
§Select§ (Ø =selected).
Setting Flash
Your phone is preset at the factory for
operation on the main connection.
For operation on a PABX, you may have
to change this value. Please refer to the
user guide for your PABX.
v
¢
Ï
¢ Telephony ¢ Flash
s Select recall and press §Select§
(Ø = set value).
Possible values are:
80 ms, 100 ms, 120 ms,
180 ms, 250 ms, 300 ms,
400 ms, 600 ms, 800 ms.
Setting pauses
Changing the pause after line seizure
You can change the length of the pause
that is inserted between pressing the talk
key c and sending the number.
v Open the main menu.
*#Q5#L
Press keys.
~ Enter digit for the pause
length (1 = 1 sec.; 2 =3sec.;
3 = 7 sec.) and press
§OK§.
Change pause after recall key
You can change the length of the pause if
your PABX requires this (refer to the user
guide for your PABX).
v Open the main menu.
*#Q5#2
Press keys.
~ Enter a digit for the length of
the pause (1 =800ms;
2 =1600ms; 3 =3200ms)
and press
§OK§.
Temporarily switching to tone
dialing (DTMF)
If your PABX still operates with dial pulsing
(DP), but you need tone dialing for a con-
nection (e.g. to listen to the network mail-
box) you must switch to tone dialing for
the call.
Prerequisite: You are conducting a call or
have already dialed an external number.
* Press the star key.
After the call is ended, dial pulsing is auto-
matically activated again.
•