User's Manual
Table Of Contents
- The handset at a glance
- Display symbols
- The base at a glance
- Contents
- Safety precautions
- Gigaset C590/C595 - more than just a telephone
- First steps
- Using the phone
- Menu overview
- Making calls
- Using the directory and lists
- Operating the answering machine on the Gigaset C595 base
- Using the network mailbox
- ECO DECT
- Setting the alarm clock
- Using several handsets
- Using a handset as a room monitor
- Handset settings
- Base settings
- Connecting the base to the PABX
- Troubleshooting
- Appendix
- FCC / ACTA Information
- Service (Customer Care)
- Accessories
- Mounting the base on the wall
- Mounting the charging cradle on the wall
- Index
46
Handset settings
Gigaset C590/C595 / USA-CAN engl / A31008-M2101-R301-1-3S19 / registr_sett.fm / 28.07.2009
Version 4, 16.09.2005
¤ Press §Save§ to save the settings.
In idle state, the destination number or
the internal destination number dis-
plays.
When the room monitor function is acti-
vated, the idle display appears as shown
below:
Changing the set destination number
v ¢ É ¢
Room Monitor
¤ Enter and save number as described in
"Activating the room monitor and
entering the destination number"
(
¢ page 45).
Cancel/deactivate room monitor
Press the end call key a to cancel the
call when the room monitor is activated.
In idle state, press the display key
§Off§ to
deactivate the room monitor mode.
Deactivating the room monitor
remotely
Prerequisite: The phone must support
tone dialing and the room monitor should
be set for an external destination number.
¤ Accept the call from the room monitor
and press keys 9 ;.
The call will end immediately and the
room monitor function will be deacti-
vated. There will be no further room mon-
itor calls.
To reactivate the room function with the
same phone number:
¤ Turn on the activation again and save
with
§Save§ (¢ page 45).
Handset settings
Your handset is preconfigured, but you
can change the settings to suit your indi-
vidual requirements.
Quick access to numbers and
functions
You can assign a number from the direc-
tory to each of the digit keys Q and
2to O.
The left and right display keys have a
function pre-selected by default. You can
change the assignment (
¢ page 47).
The number is then dialed or the function
started by simply pressing a key.
Assigning digit keys
Prerequisite: You have not yet assigned a
number to the digit key.
Press and hold the digit key.
The directory is opened.
¤ Select an entry and press
§OK§.
The entry is saved on the appropriate digit
key.
i à V
07:15 am
INT 1 Oct 22
Á
Room Monitor
9725551234
Off Options
Please note
If you delete or edit the entry in the
directory at a later date, the Quick Dial
number assignment is not updated.