Operation Manual

51
Gigaset Maxwell C / LHSG IM - IE-UK-International en / A31008-N4007-R101-1-X119 / appendix_legal_LHSG_HX.fm / 4/26/18
Template Go, Version 1, 01.07.2014 / ModuleVersion 1.0
Manufacturer's advice
Environment
Environmental management system
Gigaset Communications GmbH is certified pursuant to the international standards ISO 14001 and
ISO 9001.
ISO 14001 (Environment): C
ertified since September 2007 by TÜV SÜD Management Service
GmbH.
ISO 9001 (Quality): C
ertified since 17/02/1994 by TÜV SÜD Management Service GmbH.
Disposal
All electrical and electronic products should be disposed of separately from the municipal waste stream via
designated collection facilities appointed by the government or the local authorities.
This crossed-out wheeled bin symbol on the pro
duct means the product is covered by the Euro-
pean Directive 2012/19/EU. The correct disposal and separa
te collection of your old appliance will
help prevent potential negative consequences for the environment and human health. It is a pre-
condition for reuse and recycling of used electrical and electronic equipment.
For more detailed information about disposal of your old
appliance, please contact your local council refuse
centre or the original supplier of the product.
Care
Wipe the device with a damp cloth or an antistatic cloth. Do not use solvents or microfibre cloths.
Never use
a dry cloth; this can cause static.
In rare cases, contact with chemical substances can cause
changes to the device’s exterior. Due to the wide
variety of chemical products available on the market, it was not possible to test all substances.
Impairments in high-gloss finishes can be carefully removed using display polishes for mobile phones.
Contact with liquid
If the device comes into contact with liquid:
1 Disconnect the power supply.
2
Allow the liquid to drain from the device.
3Pat all parts dry.
4 Place the device in a dry, warm place for at least 72 hours (not in a microwave, oven etc.) with the keypad
facing down (if applicable).
5 Do not switch on the device again until it is completely dry.
When it has fully dried out, you will normally be able to use it again.