Installation Instructions

First steps

Gigaset N720 DECT IP Multicell System / engbt / A31008-M2314-L101-6-7619 / starting.fm / 29.08.2016

Version 2, 06.08.2010

Connecting base stations and DECT Manager

To be able to make calls with your Gigaset N720 DECT IP Multicell System via VoIP, the

following conditions must be fulfilled:

u The DECT Manager is installed

u Your DECT Manager and base station are connected to the local network (£ page 13)

u At least one base station is registered (£ page 16)

u At least one handset is registered to the telephone system (£ page 17)

Perform the following steps in the specified sequence, first for the DECT Manager and

then for all the base stations to be installed:

§§1§§ Connect the power cable to the device and connect to the mains power supply, if

necessary.

§§2§§ Connect the base to the router/switch to access the local network and configure via

the Web configurator.

§§3§§ Fix the device to the planned position on the wall.

Please note

Your Gigaset N720 DECT IP Multicell System is supplied with sufficient power via PoE

(Power over Ethernet) if the device is connected to an Ethernet switch with PoE

functionality (PoE class IEEE802.3af). In this case, you do not need to connect the

device to the mains power supply and step

§§1§§ can be omitted.