Installation Instructions

69
Configuring the system on the DECT Manager
Gigaset N720 DECT IP Multicell System / engbt / A31008-M2314-L101-6-7619 / web-conf.fm / 29.08.2016
Version 2, 06.08.2010
If you select the Obtained automatically option for the IP address, you will not need to
enter any further details.
If you are using static IP addresses on your local network, you will also need to enter an IP
address for each base station (
£ page 64).
The MAC addresses, the RFPI identifier (Radio Fixed Part Identity) and the RTP port range
calculated by the system are displayed for both the base station's DECT modules.
¤ Select Activate base station.
If you do not activate the base station, the data remains stored in the DECT Manager.
¤ Click Set to save the settings.
The Base Station Registration window now opens again to allow you to register and
configure the remaining base stations. When you have registered and configured all the
required base stations, the window shows that there are no more unregistered base
stations visible in the system.
You must now synchronise the base stations.
Displaying base stations, changing settings
Settings ¢ Network and Connections ¢ Base Station Settings
The Base Station Settings page shows a table of all connected base stations with the
name, RPN (Radio Part Number, number of the cell on the DECT network), cluster number,
synchronisation level and status.
¤ Click the Details button to display the settings for a base station. This opens the Own
Base Station Data screen (
£ page 68). This shows the base station's current status
and IP addresses. You can modify the IP addressing settings if required.
Workshop West
Stairwell
Workshop Central
Workshop East
Admin First Floor
Admin Second Floor
Admin Ground Floor