Installation Instructions

Configuring the system on the DECT Manager

Gigaset N720 DECT IP Multicell System / engbt / A31008-M2314-L101-6-7619 / web-conf.fm / 29.08.2016

Version 2, 06.08.2010

Starting auto-configuration

The Auto Configuration is used to update system settings. It can be started if the

manufacturer, operator or supplier of the PABX provides a corresponding file and a code.

Provider and PABX profiles

A profile contains important settings for services and functions on your telephone

system. A profile may be made available by a provider or the operator of the PABX. You

can specify on this page whether the device should check for an updated profile regularly

and load it onto your system.

Saving and restoring settings

You can save and restore the system settings via the Web page:

Settings ¢ Management ¢ Save and Restore

Once you have configured the DECT Manager and after making any changes to the

configuration, particularly registering or deregistering handsets, you should save the

latest settings in a file on the PC so that the current system can be restored quickly if

problems occur. The file is stored with the suffix .cfg (default: Gigaset-yyyy-mm-dd.cfg).

If you change the settings accidentally or you need to reset the DECT manager due to a

fault, you can reload the saved settings from the file on your PC to your phone system.

These settings can be restored via the reset button on the device (

£ page 23) or by

restoring the firmware's default settings (

£ page 100).

The file .cfg contains all system data including the DECT registration data of the handsets,

but not the call lists of the handsets.

Please note

The secure configuration file can also be loaded onto a new device.

Prerequisites:

u The old device must no longer be in operation.

u The firmware version of the new device must correspond, at least, with the version

of the device from which the data is saved, including the set patches.