User manual

Maxwell 10 / en / A31008-N4001-R102-1-20 / appendix.fm / 22.01.2014
Appendix
41
Template A4, Version 1, 03.04.2012
Appendix
Care
Wipe the device with a damp cloth or an antistatic cloth. Do not use solvents or microfibre cloths.
Never use a dry cloth; this can cause static.
In rare cases, contact with chemical substances can cause changes to the device’s exterior. Due to the
wide variety of chemical products available on the market, it was not possible to test all substances.
Impairments in high-gloss finishes can be carefully removed using display polishes for mobile
phones.
Contact with liquid
If the device comes into contact with liquid:
§§1§§ Unplug the power supply.
§§2§§ Allow the liquid to drain from the device.
§§3§§ Dry the device thoroughly.
§§4§§ Place the device in a dry, warm place for at least 72 hours (not in a microwave, oven etc.).
§§5§§ Do not switch on the device again until it is completely dry.
When it has fully dried out, you will normally be able to use it again.
Specifications
LAN 2 port LAN switch: 10 Mbit, 100 Mbit, 1Gbit
USB 2.0 type A, high/full/low host interface
Bluetooth® Class 2, IEEE 802.15.1
DECT GAP, CAT-iq1.0, EcoMode+
WLAN Standards IEEE 802.11b,g,n
Headset connections Bluetooth®, EHS, corded, USB, DECT
Power supply 100–240 V, ~50/60 Hz
Power over Ethernet PoE, IEEE 802.3af, class 3
Power consumption (standby) 4.6 W
Environmental conditions in operation ±0°C to +40°C, 10% to 93% relative humidity
Language codecs G.711 μ-law/a-law, G.722
Quality of Service (QoS) RSVP/DiffServ (RFC2474, RFC2475)
VoIP protocols SIP (RFC3261, RFC2543), RTP
VoIP security SRTP (RFC3711), TLS (RFC2246), SIPS
Internet protocols IPv4 (RFC0791), IPv6(RFC2460)
Further protocols STUN, ICE, TCP, DHCP
!