User Guide

99
Setting the base
Gigaset A510IP / USA en / A31008-M2230-R301-2-6019 / registr_sett.fm / 09.10.2012
Version 4, 16.09.2005
Entering extra codes
§Menu§ ¤
Ï
Settings ¤Telephony
Extra Codes
Select and press
§OK§.
q Select an entry ("–––" = empty entry).
§Del§ Delete a previously entered extra code if necessary.
~ Enter the extra code (maximum 3 characters, digits and the characters
"*", "#" are permitted).
Repeat the steps above until you have entered all the extra codes for your area. You
can save a maximum of five extra codes.
§OK§ Press the display key.
Activating/deactivating music on hold
§Menu§ ¤Ï Settings ¤Telephony ¤ Music on Hold
Press §OK§ to activate or deactivate the music on hold (³ = on).
Setting the base's IP address in the LAN
Prerequisite: Your base is connected to a router or a PC (¢ page 21).
An IP address is required in order for the LAN to "recognise" your phone.
The IP address can be assigned to the phone automatically (by the router) or man-
ually.
u If the address is assigned dynamically, the router's DHCP server automatically
assigns an IP address to the phone. The base's IP address can be changed
according to router settings.
u With manual/static assignment, you assign a static IP address to the phone. This
may be necessary depending on your network configuration (e.g., if your phone
is connected directly to a PC).
§Menu§ ¤Ï Settings ¤System ¤ Local Network
~ If the system PIN is not 0000: enter the system PIN and press §OK§.
Please note
To assign the IP address dynamically, the DHCP server on the router must be
activated. Please also read the user manual for your router.