Operation Manual

21
First steps
Gigaset N510 IP PRO / engbt / A31008-M2217-R101-4-7619 / starting.fm / 27.04.2012
Version 5, 23.09.2008
Entering the auto configuration code
All data required for VoIP telephony is loaded directly from the Internet to your phone.
When all the data has been successfully loaded onto your phone, Your IP account is reg-
istered at your provider. appears on the display.
No Internet connection:
The phone requires an Internet connection for you to register your telephone with a
VoIP provider. If a connection cannot be made, one of the following messages is dis-
played:
u If the phone cannot establish a connection to the router, the message IP address
not available is displayed.
Check the plug connection between the router and the base and check the settings
on the router.
Your phone is preconfigured for dynamic assignment of the IP address. In order for
your router to "recognise" the phone, dynamic IP address assignment must also be
activated on the router, i.e., the router's DHCP server must be activated.
If the DHCP server cannot or should not be activated, you must assign a fixed IP
address to the phone (
£ page 78).
u If the phone cannot establish a connection to the Internet, the message Internet
connection not available is displayed.
The IP server may be temporarily unavailable. In this case, try to make a connection
again later.
Otherwise, check the plug connection between the router and the modem or DSL
connection and check the settings on the router.
¤ Press §OK§ to close the IP wizard.
You will then need to call up the wizard later via the menu to configure the IP connec-
tion.
¤ Using the keypad, enter the auto configu-
ration code you received from the pro-
vider (max. 32 characters).
¤ Press the key below §OK§ on the display
screen.
IP Wizard
Activation code for
autoconfiguration:
< C OK