Operation Manual

Making calls

Gigaset N510 IP PRO / engbt / A31008-M2217-R101-4-7619 / telephony.fm / 26.04.2012

Version 5, 23.09.2008

Display with CNIP

If you have CNIP, then the name (location) that is registered with your network provider

for the caller's number is displayed. If the number of the caller is stored in your directory,

the CNIP display is replaced by the corresponding directory entry.

Example of display:

1Caller's number

2 Name and location

Notes on phone number display (CLIP)

The number of the caller is shown in the display of your Gigaset phone handset by

default. You do not have to change any other settings on your Gigaset telephone.

However, if the caller's number is not displayed, this can be due to the

following:

u You have not requested CLIP from your provider

u Your telephone is connected via a PABX or a router with an integrated PABX (gateway)

that does not transmit all information.

Is your telephone connected via a PABX/gateway?

You can establish this by checking for an additional device connected between your tel-

ephone and home connection, e.g., a PABX, gateway etc. In most cases, simply resetting

this device will remedy the situation:

¤ Briefly disconnect the PABX power plug. Re-insert the plug and wait for the device to

restart.

If the caller number is still not displayed:

¤ Check the CLIP (phone number display) settings of your PABX and activate this func-

tion if necessary. In the user manual for the device, search for the term "CLIP" (or an

alternative term such as "calling line identification", "phone number transmission",

"caller ID" etc.). If necessary, contact the device manufacturer.

If this does not resolve the problem, it is possible that your network provider does not

provide the CLIP service for this number.

Ø«Ú

Anna Sand,

Berlin

1234567890

for IP2

Reject Silence