Operation Manual
43
Making calls using select services
Gigaset N510 IP PRO / engbt / A31008-M2217-R101-4-7619 / netservices.fm / 26.04.2012
Version 5, 23.09.2008
Ring Delay
If you prefer to have a delay before the call is diverted, select the length of the delay at
this point (None, 10 sec., 20 sec. or 30 sec.). If you select None, the call is not signalled
on the handset and is diverted immediately.
§Save§ Press the display key.
Internal call divert is only single-stage i.e., if calls for the handset are diverted to a different
handset (e.g., MT1) on which a call divert is also active (e.g., to MT2), this second call divert
is not activated. The calls are signalled on handset MT1.
Activating/deactivating call waiting for external calls
If the function is activated, during an external call you will hear a call waiting tone to sig-
nal that another external caller is trying to get through. If you have CLIP, the number of
the waiting caller or the corresponding directory entry is shown in the display. The caller
will hear the ringing tone.
When call waiting is deactivated, the caller will hear the busy tone if you are already mak-
ing a call and you are the only party assigned to this connection.
Activating/deactivating call waiting
Prerequisite for calls via VoIP: Parallel VoIP connections are permitted on your telephone
(default setting; setting can be changed via the Web configurator).
v
¢
Ç
Select Services ¢ Call Waiting
Status Select On/Off to activate/deactivate call waiting.
¤ Press the display key §Send§.
Call waiting is activated/deactivated for all connections to the telephone and all regis-
tered handsets.
Activating/deactivating call transfer – ECT (Explicit Call Transfer)
If the Transfer (ECT) function is activated, you can connect two external callers on a VoIP
connection with each other by pressing the end call key
a
(£ page 45). This assumes
that you are making an external call via one of your VoIP connections and starting an
external consultation call.
You can activate/deactivate this function via your handset.
v
¢
Ç
Select Services
Transfer (ECT)
Select and press
§OK§ (
³
= on).
Please note
u Any call for the handset that has been diverted is entered in the call lists.
u If a call to a receive connection that is only assigned to the handset is diverted to a
handset that is not available (e.g., the handset is deactivated), the call is rejected
after a short time.
Please note
You can use the Web configurator to change further settings for the call transfer on a
VoIP connection (
£ page 104).