Operation Manual
73
Connecting/using handsets
Gigaset N510 IP PRO / engbt / A31008-M2217-R101-4-7619 / HS_and_other_Devices.fm / 26.04.2012
Version 5, 23.09.2008
External call waiting during an internal call
If you receive an external call during an internal call, you will hear the call waiting tone
(short tone). The caller's number appears in the display if Calling Line Identification is ena-
bled.
You have the following options:
Rejecting the external call
§Reject§ Press the display key.
The call waiting tone is turned off. You remain connected with the internal participant.
The external caller will hear the busy tone.
Accepting an external call/putting an internal party on hold
§Accept§ Press the display key.
You are connected to the external caller. The internal call is placed on hold.
You have the following options:
u Swap between both participants:
¤ Use
q
to switch between the participants (call swapping).
u Speak to both participants at the same time:
¤ Press the display key §Conf.§ to establish the conference call. Press the display key
§EndConf§ to return to call swap mode.
Ending an internal call
a
Press the end call key.
The external call is signalled as an incoming call. You can accept the call (£ page 37).
Internal call waiting during an internal/external call
If an internal party attempts to call you while you are involved in an external or internal
call, this call is shown on the display (internal call waiting). You can either accept or reject
this call.
Press any key to make this prompt disappear from the display.
You must end the current call to accept the internal call. Then the internal call is signalled
as per usual. You can accept the call.
Changing the name of an internal party
The names "INT 1", "INT 2" etc. are assigned automatically on registration. You can change
these names. The name must be no more than 10 characters. The changed name is dis-
played in every handset's list.
u
Open the list of handsets. Your own handset is indicated by
f
.
s
Select handset.
§Options§ Open menu.
Rename
~
Enter the name.
§Save§ Press the display key.