Operation Manual

82
Configuring the system settings
Gigaset N510 IP PRO / engbt / A31008-M2217-R101-4-7619 / settings.fm / 26.04.2012
Version 5, 23.09.2008
Assigning receive connection(s)
Prerequisite: Several connections are configured for your phone.
v ¢
Ï
Settings
¢ Telephony ¢ Rec. Connections
A list of internal parties (handsets) is displayed.
q Select the internal parties that should be assigned new receive connections
and press the display key
§OK§.
A list containing all configured connections is opened. You can select Ye s or No for each
connection.
r Select Ye s if you want the relevant connection to be the receive connection
for the internal party. Select No if it should not be the receive connection.
s Change to the next connection.
¤ Repeat these two steps for each connection.
¤ Press the display key §Save§ to save the changes.
Updating the phone firmware
Prerequisite: The phone is connected to the Internet (i.e., connected to a router,
£ page 12).
If necessary, you can update your phone's firmware.
The firmware update is downloaded directly from the Internet by default. The relevant
Web page is preconfigured in your phone.
Prerequisite:
The phone is in idle status i.e.,
u No calls are being made.
u There is no internal connection between the registered handsets.
u The base menu is not open in any of the handsets.
Starting the firmware update manually
v ¢
Ï
Settings
¢ System
Update Firmware
Select and press
§OK§.
~ Enter the system PIN and press §OK§.
The phone establishes a connection to the Internet.
§Yes§ Press the display key to start the firmware update.
Please note
u If a new connection is configured, it is assigned as the receive connection to all
internal parties and Answer Machine 1.
u If a connection is not assigned as the receive connection to any internal party, calls
on this connection will not be signalled.