Operation Manual

Configuring the phone via the Web configurator

Gigaset N510 IP PRO / engbt / A31008-M2217-R101-4-7619 / web-conf.fm / 26.04.2012

Version 5, 23.09.2008

Managing base connections – activating/deactivating

connections

You can manage your base connections using the Web page:

Settings ¢ Te lephony ¢ Connections

This Web page displays a list with all possible connections and your status (e.g., con-

nected, registered):

IP Connections

You can assign up to six VoIP connections (VoIP phone numbers) to your phone. You need

to set up a VoIP account with a VoIP provider for each VoIP phone number. You must save

the access data for each account and for the relevant VoIP provider in the phone.

A list entry is available for each VoIP connection; this is used to configure and manage the

connection.

¤ To do this, click the corresponding [Edit] button.

Configuring/deleting VoIP connections

To configure and delete VoIP connections, open the Web page

Settings ¢ Telephony ¢ Connections

¤ Click the [Edit] button next to the list entry for the VoIP connection.

This opens a Web page which you can use to set up a new account or to change the data

of an existing one.

¤ To set up a new VoIP account in the VoIP Configuration / Profile Download area, click

[Start Configuration Assistant] and then go through the steps of the configuration

assistant,

£ page 96.

In the other areas you can change the data of an existing account.

u Personal Provider Data

u General data of your service provider

u Network data for your service provider

If in the configuration assistant you have selected a provider for which there is no profile

available, you must enter all data for the VoIP account here. Your VoIP provider will give

you this data.

– If you cannot hear the caller on an outgoing call, you may have to switch between

outbound proxy server mode and STUN use. In the sent data packets, the STUN or

outbound server replaces the private IP address of your phone with its public IP

address. If you operate your phone behind a router with symmetric NAT, STUN can-

not be used.

– If you are sometimes unavailable for incoming calls, you may have to adjust the

value in NAT refresh time:

If you have not activated port forwarding or set up a DMZ on the router for the

phone, an entry in the routing table for the NAT (in the router) is required to make

the phone available. The phone must confirm this entry in the routing table at cer-

tain intervals (NAT refresh time) so that the entry stays in the routing table.

For detailed information on the areas, see the online Help for this Web page. Open the

online Help by clicking the question mark (at the top right of the Web page).