User Guide

14
First steps
Gigaset SL78H / USA/CANADA en / A31008-M2058-R301-4-6019 / starting.fm / 07.02.2011
Version 4, 16.09.2005
Display in idle status
Once the phone is registered and the time set, the idle
display is shown, as in this example. After successful reg-
istration, the following is displayed:
u The strength of the signal between the base station
and handset:
– poor to good: ÒÑiÐ
– no reception: |
u Battery charge status:
outside the charger
– U white: charged over 66 %
– V white: charged between 33 % and 66 %
– ewhite or red
*
: charged under 33 %
– =flashes red: battery almost empty (less than 10 minutes talktime)
in the charger
– = e V U white: battery is charging
*
red: older firmware version, please update the handset’s firmware (¢page 50)
Setting up area codes
Before you can return a call from the Calls list (¢ page 31), you must store the local
area code of the area in which your phone is being used. If your phone is in a mul-
tiple area code area, you must also store the extra codes for that area.
Local Area Code
v ¢
Ï
¢ Tele pho ny ¢ Local Area Code
~ Enter the local area code.
§Save§ Press the Display key.
a Press and hold (idle status).
Extra Codes
v ¢
Ï
¢ Tele pho ny ¢ Extra Codes
~
Enter the extra code.
§Save§ Press the Display key.
a Press and hold (idle status).
Repeat the above steps until all the extra codes have been entered for your area. A
maximum of five (5) extra codes can be stored.
Your phone is now ready for use!
Please note
In idle status, the calendar display can be switched on and off (¢ page 34).
i V
INT 1
Feb 14, 2009
Calls Calendar
07:15am