Instructions / Assembly

Owner’s Manual
MODEL # CT065/ Action Dome & Tepee with Tunnel
Dome= 4” x 4” x 36” / Tunnel=19” x 4’ / Tepee=38” x 38” x 60”
ASSEMBLY INSTRUCTIONS
DESCRIPTION QTY.
DOME TENT
100% Polyester 1
TEPEE
100% Polyester 1
TUNNEL
100% Polyester 1
POLES
Fiberglass Pole; Dome 2
Fiberglass Pole; Tepee 8
STAKES
Metal 8
CARRY POUCH
100% Polyester 1
Step 1- DOME SET UP
1) Spread the tent body out on the ground.
2) Fully open both of the poles.
3) Carefully thread each pole through the pole sleeves located on top of tent (Figure A).
4) Starting with one pole, insert the pole end into the footing located at bottom corner of tent. Be sure to insert pole end into the opening
closest to tent (Figure B). Bend pole and insert other end into the diagonally opposite corner of tent. Repeat process for other pole. Your
tent should now be erect.
5) Tie the straps onto the poles atop of tent (Figure C).
6) Stake the tent down (Figure D).
Step 2- TIPEE SET UP
7) Assemble and place 4 sided plastic poles into floor of tepee (Figure E).
8) Insert standing plastic pole into bottom corner hub and then insert opposite end of pole into correseponding pole pocket at top of tent.
Repeat for the other poles (Figure F).
Step 3- CONNECT TUNNEL
9) Connect tunnel to tent by securing toggles on tunnel to loops on tent (Figure G).
A
B
D
C
STEP 1
E
F
STEP 2
STEP 3
G