User's Manual

Series EK-MFR/1 EK-CDP/1 board Arch.2577
Rev. D of 28/06/2007
Pag. 10 of 19
501-000669/MN
Eurotek s.r.l.
>ODU RX Set
>>Ch Rx
It is possible, if synthesized ODU are used, to change the receiver channel. The
number of the channels are included between 1 and 256 with a step of 1.
>>Enable Rx
This menu allows to enable the receiving ODU (out door unit). If the variable “yes”
is settled, the ODU is enabled, while if the variable “no” is settled, the ODU is
disabled.
>>IF BW
It is possible to set the receiver IF bandwidth. The available value are: 8 MHz,
20MHz , 28MHz, 36MHz.
>>Rx
The Rx menu allows to set the gain control of the board. There are two possibilities:
“agc”, allows an automatic gain control while “mgc” allows a manual gain control.
>>IF2 Rx
It is possible to receive the IF frequency of the ODU when the variable “Yes” is on.
This procedure is disabled if the variable “No” is selected. When the “Yes” value is
active the yellow led located on the board panel (board panel description, E) is light.
>>Sql Lev
The user can set the Squelch level between a minimum value of –99dBm and a
maximum value of –20dBm with a step of 1dBm.
>>Sql en
It is possible, with the “Yes” parameter, to enable the Squelch. If the “No” parameter
is settled, the squelch is disabled.
>ODU TX Set
>>Ch Tx
It is possible, if synthesized ODU are used, to change the transmitter channel. The
number of the channels are included between 1 and 256 with a step of 1.
>>Enable Tx
This menu allows to enable the transmitting ODU (out door unit). If the variable
“Yes” is settled, the ODU is enabled, while if the variable “No” is settled, the ODU is
disabled.
>>IF2 Tx
It is possible to transmit the IF frequency present on the input board when the
variable “Yes” is on. This procedure is disabled if the variable “No” is selected When
the “Yes” value is active the yellow led located on the board panel (board panel
description, F) is light.