User's Manual

A4D-ESxT/1 Outdoor Multichannel Transmitter Arch. 2694
Rev. A of 8/11/2007
Pag. 22 di 30
Eurotek s.r.l.
LEGEND Fig. page 21-22
B1,B2 Bolt M10 x 25
BA1,BA2 “U” bar ø10mm with threaded M10 extremities
D1,D2,D3,D4,D5,D6 Nut M10
D7,D8,D9,D10 Nut M6
G1,G2,G3,G4 Stud M6x30mm for fastening to plate “P”
O OutDoor Unit (ODU)
P ODU support plate
A Support pole
RG1,RG2,RG3,RG4,RG5,RG6 Grower washer ø10
RG7,RG8,RG9,RG10 Grower washer ø6
RP1,RP2,RP3,RP4,RP5,RP6 Flat washer ø10
RP7,RP8,RP9,RP10 Flat washer ø6
T Roof for ODU support plate
The post assembling shall be done as follows:
Please join the cover plate (T) for the ODU to the support plate (P) by the nuts, the washers (flat and
grower) and bolts ø10, fitting the holes on to the plates. (see fig. page 21).
Then, please fasten the overall composed by the plates (P)+(T) to the support pole (A) by the “U”
bars (BA1&BA2) and relative four nuts and washers (flat and grower) ø10. (see fig. page 21).
Now, we have to fasten the ODU (O) to the support plate (P) fitting the four studs (G1÷G4) with the
special holes by the four nuts and washers (flat and grower) ø6.