Installation Guide

4
UNPACKING YOUR ICE MAKER
Warning:Please keep foam and other packaging materials from children and disabled
people, as this may cause danger to them.
NOTE: Please remove all packages when using,or else the machine may not work properly.
a) Remove the packaging and check whether the machine is intact.
b) Open the accessory package and check whether the below accessories are included.
Accessories list
NO
Description
Picture
Usage
QTY
1
Manual
Operation manual
1PC
2
Filter
Filter water
1PC
3
Spanner
Twist the filter off or on
1PC
4
Fixed plate
Fix the filter
1PC
5
Screw
To fix the filter
6PCS
6
Drainage pipe
Drain
1PC
7
Ice spoon
Take ice cubes
1PC
8
nylon cable ties
Fix pipe if needed
2PCS
9
Hoop
Fasten the drainage pipe together if
needed
1PC
10
Seal ring
Spare.Put in the joint which connects the
faucet.
1PC
11
Seal ring
Spare.Put in the other joint of filter.
1PC
12
Spare blue clip
Spare blue clip if needed.
2PCS
13
Spare plug
Spare plug which plug the tank if needed.
1PC
14
Feet
Screw fee before using the machine
4PCS
15
PTFE Tape
Tie up the connector if needed
1PC
9
increase the making time in minute.
B:When the machine is at the middle of ice making or standby mode,hold the button for 2s
tosettheauto-turning-on or auto-turning-on time(The time range is from 0-23 hour,in
hours).
7.
A: When the machine is at the middle of ice making, press the“Light/-” button to reduce
the making time in minute.
B:Hold the button for 2s to turn off the blue light when the light is on.
Hold the button for 2s to turn on the blue light when the light is off.
8.
A: the countdowntime for the ice making procedure orreservation time or “replenishing water”
or standby mode.
B: “--” and standby indicator mean the machine is in standby mode.
C: “00”,”add water” and “ lack of water” indicator mean the machine is replenishing water.
CLEANING & MAINTENANCE
Please thoroughly clean your ice maker before initial use.
EXTERIOR: the outside of the ice maker should be cleaned regularly with a mild detergent
and warm water. Always use a soft cloth to avoid scratching or damaging the housing.
SPOON: clean with mild detergent and warm water in week.
Storage tank: clean with mild detergent and warm water in week.
PUMP: clean with mild detergent and warm water in week. Turn off and unplug the
machine,take the pump out,clean it with a brush then install it back.
INTERIOR: please use the following Self-Clean function:
1. Add water and vinegar or lemon juice mix (1:1 ratio)
2. Plug in unit,press and hold the CLEAN button for approximately 6-7 seconds,then
release.The unit will automatically enter Self-clean program. This process takes about 5-
6 minutes.When the Self-Clean program is finished,unit will automatically power off.
3. The fan blade will be rotating.This process rinses the inside parts several times.
4. After the Self-Clean program is completed,unplug the power cord and drain out the water
by unplugging the drain cap on the side.Replace drain cap.
5. Add fresh water to the water reservoir,up to the water level mark.
6. Plug the unit and repeat the Self-Clean process by repeating steps 3 to 5. This will rinse
out the vinegar/lemon residue.
7. After draining the water,replace and tighten drain cap.
8. Dry the interior and exterior with a clean,soft cloth.
NOTE: It is strongly recommended to clean the unit before initial use or after the unit has
not been in use for a long period of time.