User Manual

Installation
Page 12 MDE-4199 Contactless Smart Card Retrofit Kit M05205K00X Installation Manual • January 2005
Completing Installation for the Encore Units
Perform the following steps to complete installation.
1 Close and secure the main doors.
2 Close and secure the CIM Doors
3 Install the appropriate graphics.
4 Restore power to unit. Refer to MDE-3893 Encore/Eclipse Owners Manual.
5 Upgrade the CRIND BIOS using the Laptop Tool Software. See MDE-3921 for complete
instructions on loading the Laptop Tool Software.
6 Test the RF Readers by sliding CRIND Diagnostic Card Q12534 through both readers the with
the magnetic strip up.
7 Verify that a valid read was made from the diagnostic card.
8 Pass the Contactless Smartcard test card in front of the RF antenna (flat side toward antenna).
9 Verify that a valid read was made from the test card.
10 Apply appropriate graphic logos. These are order entry items. See MDE-2620 for graphic
application instructions.
Installing M05205K002 Kit in an Eclipse Unit
The M05205K002 Kit contains parts for both side 1 and side 2 of the Eclipse Unit. Therefore,
all procedures performed on Side 1 of the unit must also be performed on Side 2.
Installation of the PayPass RF Reader Kit M02139K002 for the Eclipse units involves
performing the following categories of installation:
•“Preparing for Installation” on page 12
•“Removing the Eclipse Existing Card Reader” on page 14
•“Installing the Eclipse Dual Head Card Assembly” on page 15
•“Installing the Antenna PCA” on page 17
•“Completing Installation for the Eclipse Units” on page 17.
Preparing for Installation
Perform the following steps to prepare for the installation of PayPass RF Reader Kit
M02139K002 for an Eclipse unit.
1 Read all instructions before beginning.
2 Observe all safety precautions.
3 Obtain approval from store manager or responsible personnel to remove unit from service.
4 Remove power from the fuelling unit. Refer to MDE-3804 Encore and Eclipse Series Start-
Up/Service Manual.