User Manual

MDE-4199 Contactless Smart Card Retrofit Kit M05205K00X Installation Manual • January 2005 Page 15
Installation
Figure 7: Rear View of CIM Door with Card Reader
2
Remove the four nuts that secure the card reader bracket and the card reader (Figure 7) to the
CIM Door using a 9/32-inch nut driver. Discard the card reader. Retain the bracket and screws
for reinstallation.
Note: Make note of the card reader gasket orientation on the card reader, this information will
be useful when installing the new M00282B001 Card Reader Gasket. Also, ensure that
the option door surface has been cleaned with isopropyl alcohol and a clean cloth prior
to installing the new M00282B001 Card Reader Gasket.
3 Completely remove the old card reader gasket from the old card reader. Use a putty knife if
necessary.
Installing the Eclipse Dual Head Card Assembly
Perform the following procedures to install the card reader.
1 Remove the adhesive backing from the M00682B001 Card Reader Gasket and place the
gasket over the card reader opening from the inside of the opened CIM door.
2 Obtain the M03311A001 Dual Head Card Assembly (Figure 8) and M05543B001 Card
Reader Shield (Figure 8) from the kit, and assemble the reader and shield for installation onto
the option door.
Note: The shield is positioned on the same side as the printed circuit card on the card reader
with the lip of the shield toward the card reader.
3 At the rear of the CIM door, position the card reader and shield in the door such that the card
reader slot (Figure 8) is positioned on the top.
Nuts Hold
Assembly
Together
Cable Harness
Nuts Hold
Assembly to
the CIM Door
Card Reader Bracket
Card Reader