User Manual

MDE-4199 Contactless Smart Card Retrofit Kit M05205K00X Installation Manual • January 2005 Page 17
Installation
9 Ensure that the all Ground Cables are secured to the unit with sufficient slack to prevent cable
pulls and pinching.
Installing the Antenna PCA
The RF antenna must be located directly behind the area where the logo graphic is attached.
Looking at the back of the oven door, the antenna will be located on the right side just above
the center of the door (to the right of the keypad).
Install the antenna as follows:
1 Locate the area where the RF antenna will be mounted.
2 Using isopropyl alcohol, clean the mounting surface.
3 Locate the M05170A001 Antenna PCA in the kit and peel the protective cover from the foam
adhesive strips on the antenna.
4 Position the antenna on the back of the oven door to the right and just above the center of the
door (to the right of the keypad) and attach it to the door surface by pressing the foam adhesive
firmly to the door.
5 Using two Q11657-290 screws (part of the kit), secure the antenna in place by inserting the
screws in the mounting holes and turning the self-tapping screws into the oven door.
6 Connect one end of the M04124A002 Antenna Cable to the two-pin connector on the antenna
PCA and the other end to the 2-pin connector on the dual head card assembly shown in Figure
8.
Completing Installation for the Eclipse Units
Perform the following steps to complete installation.
1 Close and secure the Oven and CIM doors.
2 Install the appropriate graphics.
3 Restore power to unit. Refer to MDE-3893 Encore/Eclipse Owners Manual.
4 Upgrade the CRIND BIOS using the Laptop Tool Software. See MDE-3921 for complete
instructions on loading the Laptop Tool Software.
5 Test the RF Reader by sliding CRIND Diagnostic Card Q12534 through the with the magnetic
strip up.
6 Verify that a valid read was made from the diagnostic card.
7 Pass the CRIND Diagnostic card in front of the RF antenna (flat side toward antenna).
8 Verify that a valid read was made from the diagnostic card.
9 Apply appropriate graphic logos. These are order entry items. See MDE-2620 for graphic
application instructions.