User Manual

Installation
Page 18 MDE-4199 Contactless Smart Card Retrofit Kit M05205K00X Installation Manual • January 2005
Installing M05205K003 Kit in The Advantage Series Unit W/O Cash Acceptor
The M05205K003 Kit contains parts for both side 1 and side 2 of The Advantage Series Unit
with ADA Single Line or Monochrome Infoscreen.
If both sides of the unit are being updated, all procedures performed on Side A of the unit must
be performed on Side B also.
Removing the Card Reader from the Advantage Series Unit
When installing a PayPass RF Reader Retrofit kit, the existing card reader must be removed
and replaced with a dual head card assembly (part of the kit). Remove the existing card reader
as follows:
1 Read all instructions before beginning procedure.
2 Observe all safety precautions.
3 Obtain approval from store manager or responsible personnel to remove unit from service.
4 Remove power to the units. Refer to MDE-2540 The Advantage, Legacy, and MPD Series
Owners Manual for details on removing system power.
5 Locate left and right options doors. Using the key, open the left and right option doors.
6 From side A, unlatch the four draw latches located behind the right and left options doors. Use
a 5/32-inch Allen wrench or 3/8-inch Hex to loosen the four screws at bottom of main access
door.
7 From side A, open the main access door by lifting slightly. Place the main access door hinge
bracket pin into the end slot/lock position. This locks into a maximum 90° angle.
8 Remove the cable clamp (Figure 10) attached to the card reader mounting bracket.