User Manual
Table Of Contents
Introduction
Page 2 MDE-4199 Contactless Smart Card Retrofit Kit M05205K00X Installation Manual • January 2005
Required Reading
Before installing this kit, the installer must read, understand, and follow:
• this manual
• NFPA 30A, The Automotive and Marine Service Station Code
• NFPA 70, The National Electric Code
• applicable federal, state and local codes and regulations
Failure to do so may adversely affect the safe use and operation of the equipment.
Note: This kit must be installed by a Gilbarco Authorized Service Contractor (ASC) to insure
warranty.
Related Documents
The following documents are related to the installation of the Contactless Smartcard Reader
Kit:
Required Tools
The following tools are needed to install Contactless Smart Card Retrofit Kit:
• IC Extraction Tool, Digikey K158-ND (or equivalent)
• IC Extraction Tool, AMP 821903-1 (or equivalent)
• isopropyl alcohol (part number END-1082)
• nut drivers, 1/4-inch, 8 mm, 3/8-inch, 9/32-inch
•putty knife
• contactless smart card test card
• ratchet set, standard
• screwdrivers, flat blade and cross tip
• static guard wrist strap
Document
Number Title GOLD
®
Library
MDE-2540 The Advantage, Legacy, and MPD Series Owners Manual The Advantage and Legacy Models
MDE-2562 CRIND Service Manual CRIND and TRIND
MDE-2620 Graphics Panel Application for The Advantage Series,
Encore and Eclipse
The Advantage Series and Legacy
Models, Encore and Eclipse
MDE-3804 Encore/Eclipse Startup/Service Manual Encore and Eclipse
MDE-3893 Encore/Eclipse Owners Manual Encore and Eclipse
PT-1728 The Advantage Series Illustrated Parts Manual Parts Manual
PT-1736 CRIND Illustrated Parts Manual Parts Manual
PT-1936 Encore Series Pump and Dispenser Parts Manual Parts Manual
PT-1938 Eclipse Series Pump and Dispenser Parts Manual Parts Manual