User Manual

Installation
Page 20 MDE-4199 Contactless Smart Card Retrofit Kit M05205K00X Installation Manual • January 2005
11 Using a 1/4-inch nut driver, remove the four hex head fasteners (Figure 11) that secure the card
reader bracket (Figure 11) and the card reader to the options door. Dispose of the card reader.
Note: Make note of the card reader’s gasket orientation. This information will be useful when
installing the new M00682B001 Card Reader Gasket. Also, ensure that the option door
surface has been cleaned with isopropyl alcohol and a clean cloth prior to installing the
new card reader gasket.
12 Remove the old card reader gasket (Figure 11) from the options door. Use a putty knife if
necessary.
13 If installing a dual head card assembly on Side B, repeat steps 1 through 11.
Installing The Contactless Smartcard Reader
1 Remove the adhesive backing from the M00682B001 Card Reader Gasket and carefully place
the gasket over the card reader opening from the inside of the opened option door.
Note: Fueling units that contain the InfoScreen option may require the removal of the lower
right Infoscreen fan screw (Figure 11) to allow installation of the new RF Reader
bracket. The screw may be discarded once the installation has been completed.
2 Obtain the M03311A001 Dual Head Card Assembly (Figure 12) and T19632-02 Card Reader
Mounting Bracket (Figure 12) from the kit, and assemble the reader and bracket for
installation onto the option door.
3 From the rear of the option door, position the card reader and bracket in the door such that the
card reader slot (Figure 12) is positioned on the top.
Figure 12: Dual Head Card Assembly and Card Reader Mounting Bracket
4
Secure the card reader and bracket to the door using three of the Q11677-24 screws. Leave the
fourth screw (lower left) out for securing ground cable later. Reattach the cable clamp to the
new bracket.
Card Reader Slot
M03311A001 Dual Head Card Assembly
Card Reader Mounting Bracket T19362-02
Printed
Circuit
Card
2 Pin
Antenna
Connector
7 Pin
Power/Data
Connector
2 Pin ESD
Ground
Connection