User Manual

MDE-4199 Contactless Smart Card Retrofit Kit M05205K00X Installation Manual • January 2005 Page 23
Installation
Figure 15: PCA Antenna Location
11
Connect the M04124A003 antenna cable to the two-pin connector (Figure 12) on the Printed
Circuit Card located on the left side of the dual head card assembly.
12 Connect the other end of the antenna cable to the 2-pin RF connector on the dual head card
assembly (Figure 12).
13 Properly dress the cables to avoid pinching during door opening and closing. Use Q13558-04
Cable Mounts as required.
14 Obtain the M02962B005 FCC Decal and the N23951-09 UL/CA Recognition Decal from the
kit, and from Side A of the dispenser affix the decals to the inside of the column sheathing
location on the right.
15 Repeat steps 1 through 13 if installing on Side B.
Upgrading the BIOS for the CRIND Logic Z180 PCA
Note: This Basic Input/Output System (BIOS) upgrade is needed for dual head and
contactless card reader functionality. Contact the Gilbarco Technical Assistance Center
(TAC) at 1-800-743-7501 for the minimum version of CRIND BIOS required to operate
the Dual Head Card Reader.
M05170A001
PCA Antenna
Cable To 2-Pin
Connector On
M03311A001
Dual Head Card
Assembly
Card Reader
Antenna
Mounting
Holes
Refer to Figure 12 and ensure that the Antenna Cable is inserted into the 2 PIN Antenna
connector on the dual head card assembly. Failure to connect the cable properly will damage
the card reader.
CAUTION