User Manual

MDE-4199 Contactless Smart Card Retrofit Kit M05205K00X Installation Manual • January 2005 Page 27
Installation
3 Obtain approval from store manager or responsible personnel to remove unit from service.
4 Remove power to the units. Refer to MDE-2540 The Advantage, Legacy, and MPD Series
Owners Manual for details on removing system power.
5 Locate left and right options doors. Using the key, open the left and right option doors.
6 From side A, unlatch the four draw latches located behind the right and left options doors. Use
a 5/32-inch Allen wrench or 3/8-inch Hex to loosen the four screws at bottom of main access
door.
7 From side A, open the main access door by lifting slightly. Place the main access door hinge
bracket pin into the end slot/lock position. This locks into a maximum 90° angle.
8 Remove the cable clamp (Figure 19) attached to the card reader mounting bracket.
Figure 19: Left Options Door Opened
9
Disconnect the data/power cable connection (Figure 20) from the card reader.
Cable Clamp
Card Reader